If you are installing the GARADAM further back behind the tracks, it is recommended to purchase the GARADAM SIDE CAPS to prevent water building up and spilling over the sides of the GARADAM.
One side of the SIDE CAP is contoured to ensure a tight fit with the GARADAM. It is this side that should be in contact with the seal.
The Side Cap should be attached to the GARADAM using the adhesive supplied with the threshold.
You should mark out on the threshold where the SIDE CAP will go with a pen, and then apply the adhesive in a zigzag pattern.
The SIDE CAP should be placed into position and pushed down firmly to ensure a tight fit.
The SIDE CAP can be cut using a sharp knife/hacksaw if it needs to be altered to fit around the tracks.